Wigs Can this wig be straightened?

Have you tried dipping it multiple times in really hot (not boiling) water and letting it drip-dry? You should test a little piece (preferably in a spot that won't normally be seen) by dipping it in the hot water. I usually ball up paper towels inside of the wigcap to shape it and sit it on a bottle to drip-dry overnight.

If you do choose to use a hair straightener on it, be sure to do it in an area where, if it melts the hair, it won't be seen if you need to cut it off the wig.

Ryu

 

I've straightened leeke heat resistant wigs before and not had any issue. My straightener doesn't have any temp control though, so I went at it as soon as it was getting warm and unplugged it soon after it was warm enough. It's probably a good idea to work quickly just in case.

 

This.

Basially test it on just a couple of strands at the back of the neck to see if it works before trying it on the main body of the wig. I don't have hair straighteners but I've straingened and de-frizzed wigs and doll hair using my regular clothing iron on the synthertics setting. It's best to spray the fibres with water, I've found, beofre putting the heat to them, but your experience with the straighteners may vary.

I've had a lot of success with the hot water method, but don't know if I've done it specifically on a Leeke wig sio don't k now if the fibres they use will straighten. Mostly I use the hot water method to get rid of one style and add another (put the hair in curlers, dunk in hot water to relax it into the new style then dunk it in iced water to set the new curls, for example).

Teddy

 

It says on the page that it's heat-resistant, so I think it should be fine to use a low temperature hair straightener - but as other users said before, on one small strand of hair that's not visible, so you can cut it off if it turns out to not be so resistant.
However, the hot water metod also works really well!

 

Leeke wig fibers do respond well to the hot water method. I had one years ago that came with more subtle waves in it, and I used hot water to straighten the existing waves and then re-curl the whole wig into ringlet curls. It worked well and held the new style for as long as I had the wig. So I'd recommend @Ryuichi Sakuma 13 's suggestion first, and then if for some reason that doesn't give you the results you're looking for, definitely test the straightener on a hidden piece at the back, like everyone else has said.

 

Your straightener on low isn’t going to hurt the wig. That’s the whole point of heat resistant fibers. I would definitely make quick passes on small sections of hair at a time to keep the heat moving on the head, but it should be fine.

You could also use the hot water method, but I’d recommend dipping only the parts you want to straighten in if you go that route, because otherwise you’ll have to reshape the bangs and if they dry in a weird configuration you’ve made more mess than you’ve fixed.

 

Good point

Teddy

 

One of my favorite techniques is using a steamer that you’d use for your clothes. You can wave the wig in the steam and brush through. It’s a little more gentle than dipping directly into the water.

 

I also straightened one leeke wig, but I did it very carefully and firstly I did it only at inner part to understand whether I will ruin it or not. I believe, if everything will be good with the material, you'll be able to curly it again if you don't like the result of straightening